Contents

• 1 Mini Colour Camera
• 1 Control Unit
• 1 Switcher Box
• 4 Bumper Fit Sensors
• 2 Cutting Tools
• Warning Buzzer
• 1 Wiring Harness
• Fitting Accessories

 

How it works
The system works by radiating ultrasonic beams covering the area behind the vehicle. The beams are reflected by obstructions behind the vehicle, and re-enter the sensors. The reflected beam information is processed to calculate the distance of the obstruction.

As with the other systems the Veba's are activated when reverse gear is engaged. As the vehicle is reversed. When the vehicle is less than 1.5 metres from the obstruction the audible alert will emit intermittent bleeps. As the vehicle gets closer to the obstruction the display indicates the reduction in distance and the frequency of the bleeps increases. At 45 centimetres from the obstruction the bleeps become a continuous solid tone.

The Veba recess systems can also be attached to the front of a vehicle for all-round protection. In this instance the power lead needs to be wired into the fuse box rather than the reversing light so that power is always on when the car is in ignition. We suggest the fuse for the car stereo or interior lights.

Optional Wedge Included

This system comes with an optional wedge, giving greater flexibility according to the shape of your bumper.  The wedge can be used if your bumper is slightly angled up- or downwards, to ensure the sensor's signal is still sent out parallel with the road's surface.  If your bumper is vertical, then the wedge can be removed to flush-mount the sensors instead.  See pictures below.

Technical Specification

• Rated Voltage (range) - 12V(10.5V~16V DC)
• Rated Current - 200mA~600mA
• Detection Distance - 0.2m~1.5m
• Camera Viewing Angle - 90⁰
• Sensor Frequency - 40KHz
• Working Temperature of ontrol Box - -30~+80

Some Useful Measurement Information (measurements are approximate and not guaranteed)
Component	Length x Width x Depth
Size of Control Box	112mm x 102mm x 25mm
Size of Switch Box	109mm x 69mm x 20mm
Size of Speaker	75mm x 50mm
Size of Ultrasonic Recess Sensors	24mm x 20mm
Size of Camera	43mm x 75mm x 30mm
Diameter Size For Sensor Drilling	21mm (Drill Bit Supplied)
Diameter Size For Camera Drilling	25mm (Drill Bit Supplied)
Length of Speaker Cable	2m
Length of Sensors Cabling	2.5m
Length of Camera Power Wire	2.5m
Camera Connection Wires	10m
Data Wire (Connects Control Box to Switcher Box)	10m

Maintenance
No routine maintenance or adjustment is required. Dirt, frost or snow accumulated on the sensors may cause the system to activate incorrectly. Clean carefully with a soft cloth. Do not use chemicals or spirits. Applying hot water in frozen conditions may damage the sensors. The sensors can be washed carefully with warm soapy water.