What You Get
The Dolphin is a 4 recess mounting sensor high quality system that will cover the widest of cars giving a professional finish. Included with the 4 recess sensors is a buzzer which gives audible bleeps with increasing frequency as you get closer to an obstacle. |
|
Kit Contents
- 4 Sky Blue Recess Bumper Fit Sensors
- 1 Control Unit
- Buzzer Unit
- 1 Cutting Tool
- Fitting Accessories
- Instruction Manual
How it works
The system works by radiating ultrasonic beams covering the area behind the vehicle. The beams are reflected by obstructions behind the vehicle, and re-enter the sensors. The reflected beam information is processed to calculate the distance of the obstruction.
As with the other systems the Dolphin unit is activated when reverse gear is engaged. As the vehicle is reversed. When the vehicle is less than 1.5 metres from the obstruction the audible alert will emit intermittent bleeps. As the vehicle gets closer to the obstruction the frequency of the bleeps increases. At 20 centimetres from the obstruction the bleeps become a continuous solid tone.
Stage |
Distance |
Awareness |
Alarm |
1 |
200 - 160cm |
Safe Mode |
No |
2 |
150 - 100cm |
Safe Mode |
Bi----Bi----Bi |
3 |
90 - 50cm |
Alarm Mode |
Bi--Bi--Bi |
4 |
40 - 30cm |
Alarm Mode |
Bi-Bi-Bi |
5 |
0 - 20cm |
Danger Mode |
Bi---------- |
Optional Wedge Included
This system comes with an optional wedge, giving greater flexibility according to the shape of your bumper. The wedge can be used if your bumper is slightly angled up- or downwards, to ensure the sensor's signal is still sent out parallel with the road's surface. If your bumper is vertical, then the wedge can be removed to flush-mount the sensors instead. See pictures below.
Technical Specification
- Rated voltage (range) DC12V
- Power 3.6W
- Detecting Angle H>60, V>60 degreese
- Detection Distance 0.3~2m
- Sensor Frequency 315MHz/433MHz
- Working temperature of control box -20 ~+70
Some Useful Measurement Information
(measurements are approximate and not guaranteed) |
| Component |
Length x Width x Depth |
Size of Buzzer
|
59mm x 40mm x 17mm
|
Size of Processor |
96mm x 68mm x 26mm |
Size of Ultrasonic Recess Sensors |
25mm x 22mm |
Diameter Size For Drilling |
21mm (Drill Bit Supplied) |
Length of Sensors Cabling |
2m |
Length of Cabling for Buzzer |
2m |
Maintenance
No routine maintenance or adjustment is required. Dirt, frost or snow accumulated on the sensors may cause the system to activate incorrectly. Clean carefully with a soft cloth. Do not use chemicals or spirits. Applying hot water in frozen conditions may damage the sensors. The sensors can be washed carefully with warm soapy water
Also available in 7 other colours:-
*Please use these colours as a guide only due to different screen settings it is impossible to see exact colours.
